Development happens on github and the preferred contribution method is by forking the repository and issuing a pull request. Alternatively, just sending a patch to email@example.com will work just as well.
If you don’t know git (or another distributed version control system), which is a fantastic tool in general, there are several good git and github tutorials. You can start with their official documentation.
If you compile mahotas in debug mode, then it will run slower but perform a lot
of runtime checks. This is controlled by the
DEBUG environment variable.
There are two levels:
DEBUG=1This turns on assertions. The code will run slower, but probably not noticeably slower, except for very large images.
DEBUG=2This turns on the assertions and additionally uses the debug version of the C++ library (this is probably only working if you are using GCC). Some of the internal code also picks up on this and adds even more sanity checking. The result will be code that runs much slower as all operations done through iterators into standard containers are now checked (including many inner loop operations).
The Makefile that comes with the source helps you:
make clean make debug make test
will rebuild in debug mode and run all tests. When you are done testing, use
fast Make target to get the non-debug build:
make clean make fast
Using make will not change your environment. The
DEBUG variable is set
If you don’t know about it, check out ccache
which is a great tool if you are developing in compiled languages (this is not
specific to mahotas or even Python). It will allow you to quickly perform
make clean; make debug and
make clean; make fast so you never get your
builds mixed up.